miller furnace m1m with red led code 1 flash
l have this code flashing/blower does not work,tried to jump upper limit
switch,also tried jumping lower limit.still flashes code limit openhelp
please
you have to reset the board by turning power off for a few
seconds,then back on..instead of jumping out the high limit,,try taking it
out & tap on the ''klixon'' part at the end of the insertion bars { .if one
of the ''rollout limits '' on or near the burner box is tripped,you will
have to manually reset it by pushing in on the reset button in the middile
of it,,if thats the problem,get furnace checked,rollout limits should never
trip [open]..} ..that might get to reset long enough for temporary service while you get a new high limit switch.best not to jump it out except for diagnosing the problem,,,if blower motor were to fail to come on while high limit was jumped out,the furnace would ''chernobyl''..be sure to check filter,wash or replace if necessary.does blower work??...dan
turn the power off to it wait 1 minuit turn it back on
push the reset button
5 posts
• Page 1 of 1
do LED's produce a steady light or flash like Florescents Samsung Syncmaster 913n fast flashing green led How much should I expect to pay for installation on a LED Underbody kit? problem with sony ericsson k810i phone?camera flash stopped working? i want a mobile with LED flash in range of rs 8000 How do i sort the effects out on my behringer djx700 mixer,the led just flashes? When I put my ear near my hardrive I hear a buzzing sound and the LED light always flashes LED Light flashing red on front of computer, won't start Why is the LED on the controller of my RC Alany helicopter flashing? I cannot operate the helicopter. Help!!?? HELP! I just got a LED scrolling belt buckle. Lost instructions. Can't turn off flash feature!? please help? Why does the Red indicator on my Blackberry flash? motherboard power LED flashes continuously, what is it saying Does the Nokia E65 have a standby LED? simple led flasher circuit question Who is onlineUsers browsing this forum: 4 guests |